patch-2.4.7 linux/arch/cris/drivers/Config.in

• Lines: 31
• Date: Wed Jul 4 11:50:38 2001
• Orig file: v2.4.6/linux/arch/cris/drivers/Config.in
• Orig date: Tue May 1 16:04:56 2001

diff -u --recursive --new-file v2.4.6/linux/arch/cris/drivers/Config.in linux/arch/cris/drivers/Config.in
@@ -6,10 +6,21 @@
 # this is just so that the user does not have to go into the
 # normal ethernet driver section just to enable ethernetworking
   define_bool CONFIG_NET_ETHERNET y
+  
+  choice 'Network LED behavior' \
+  "LED_on_when_link      CONFIG_ETRAX_NETWORK_LED_ON_WHEN_LINK    \
+   LED_on_when_activity  CONFIG_ETRAX_NETWORK_LED_ON_WHEN_ACTIVITY" \
+     LED_on_when_activity
+
 else
   define_bool CONFIG_NET_ETHERNET n
 fi
 
+bool 'Etrax Ethernet slave support (over lp0/1)' CONFIG_ETRAX_ETHERNET_LPSLAVE
+if [ "$CONFIG_ETRAX_ETHERNET_LPSLAVE" = "y" ]; then
+  bool '  Slave has its own LEDs' CONFIG_ETRAX_ETHERNET_LPSLAVE_HAS_LEDS
+fi 
+
 bool 'Serial-port support' CONFIG_ETRAX_SERIAL
 if [ "$CONFIG_ETRAX_SERIAL" = "y" ]; then
   comment '  Port 0 is always enabled'
@@ -99,7 +110,7 @@
 	define_bool CONFIG_BLK_DEV_IDEDMA y
 	define_bool CONFIG_DMA_NONPCI y
 	
-	int 'Delay for drives to regain consciousness' CONFIG_IDE_DELAY 15
+	int 'Delay for drives to regain consciousness' CONFIG_ETRAX_IDE_DELAY 15
 	
 	choice 'IDE reset pin' \
   	"Port_PB_Bit_7  CONFIG_ETRAX_IDE_PB7_RESET\